Pallet Equipment For Sale

Baker High Capacity Deduster

The Baker M4i DeDuster has been designed to be a super-high-performance dust removal machine that will accept and remove sawdust from the highest production multi-head horizontal band resaw today. The M4i DeDuster can operate at over 700 feet per minute! Boards drop into the M4i DeDuster hopper. The hopper’s height adjustment (for the amount of lumber), indexable stops (for the length of the lumber), and adjustable fence (for the width of the lumber) allow you to set it up for the most efficient operation. This virtually eliminates jam-ups. The hopper’s variable-speed conveyor sends the lumber through the M4i DeDuster chamber one piece at a time. The rear height adjustment of the conveyor can be adjusted from a minimum of 24" and up to 34" maximum. Inside the M4i DeDuster chamber, high-speed brushes clean all four sides of the boards. The independently powered brushes are fully adjustable for longer brush life. The specially designed chamber maximizes air flow, directing the dust out the dust chamber instead of back onto the boards. The entire side of the chamber easily opens for full open accessibility. The Baker M4i DeDuster comes with its own electrical panel and a stand-mounted, remote start/stop control station.

This is a slightly used 2022 model 26” air activated chop saw with a 15hp motor wired for 480 voltage. It comes complete with the electric panel and controls. It has a 10’ idler infeed roll case with fence and a 5’ idler outfeed with a 48” stop bar and 4 manual stops.

Baker 6-head resaw, electric drive, good working condition

Late 90's model | 480v

BBR-0 | Electric Drives | No Hydraulics | 30 HP Motors | 1992

2 - Baker Stacking Racks available

2019 Baker Ambi-Trim | 6 Heads | Infeed System w/ Unscrambler | 20' Max Length | Good Running Condition | 480V

2013 Baker M4I DeDuster with hopper infeed and variable speed drive and three 2hp brush heads. Electric complete with 480 voltage, panel, and pedestal mounted start and stop station. $6,500.00

480V | Model # BDD-O | Serial # 19-552

480V | Model # BBR-0 "A" | Serial # 09-4089

Model C 20 HP W Return Over Head Side Power Rollers

Baker board deduster, up to 8" wide capacity, electric drive, price includes all new brushes, feed belt and gone through completely, very good condition

Baker Pallet Notcher 2020 or 2021 Single head 3 stringer Has hyd but was line shaft driven when used Used very little

Baker Chamfer Machine

Baker Pallet De Stacker

Baker M4 In Line Deduster

Bob Hannah Board Chamfer

Bob Hanna Double Head Notcher -The notcher has been in production -Replaced electrical -Replaced Bearings and anything that was needed to make the machine run flawlessly -Production rate is 1 notched stringer per second -Hard to find and extremely reliable

4x6 Speed Cut