4' x 6' Table Hand controller ____ capacity

12x70 Triple Pass Drum McConnell Biomass Burner has gas startup: Will need new brick after moved. Includes: Drum trunnions, motors, gear and end caps

This unit was blowing dust to a large baghouse in a large facility. There is also a 75 HP blower and baghouse available at the same location. Piping is available. Unit will be loaded on the truck.

10 HP Dust Fan with ductwork 230/460 volt 3-phase

4 banks of 15 fans as pictured

Blower with Century 7-1/2 HP motor 208/239/460 volt 3-phase

8x24 Drum Dryer Webb stye burner Includes: Drum, burner, cyclone ductwork and blower

Table Top Measures 50x50 Hand Operated Air Valve To Raise & Lower Lower Height is 12 1/2 Total Raised Height is 27 1/2 All Air Operated 4,000 lb Capacity

MAT Drill System Infeed Trim Saw Drilling Outfeed

This turntable is in great condition. Taken out of production a month ago for upgraded. Sew-Eurodrive Motor Volts: 230/460 Hz: 60 Rpm: 1751

Spray booths - (3) Available Approx 15'x12'

Chop Saw with Infeed Unscrambler Swing cut off with a 12" blade 5 HP Motor

????34' kiln with 5,500 BF of 4/4 lumber capacity Hot water system wood/oil boiler combo Wet bulb/dry bulb with 7 fans that change directions for air flow on adjustable timers 2 16'x5' karts Unit comes with 2 axles, tires, skirting for bottom enclosure, panel box with switches and timers

2021 heavy duty 7.5 HP Used Dust Collector 220 V / 3 Ph / 60 Hz Dust Collector has an efficiency of 85%

75 HP 550 Volt 3 phase

15 HP 460 volt 3-phase 63 CFM Capacity

USNR 60,000 Board Foot Kilns (10) Available

Vac-U-Clamp FT900 Thermafoil mPress Brand new - Seller never used it!

Vac-U-Clamp FT800+ Thermofoil Press 52" x 105" Work area Dispenser Rack (3) Vac bags new in boxes still

The Vantec Veneer Auto Stacker, ELV 1.82B is a Vacuum stacker for 2800 mm Veneer lathe. It is fitted with double stacking system (04 bins), with four veneer transport lines and four 5hp exhausters. with of two stoppers and eight ejecting arms. With drive Panel, VSD for exhaust fans and hydraulics lifting tables. Min veneer sheet length sheet: 2300 mm; • Max veneer sheet length sheet: 2700 mm (or Two sheets of 1350mm); • Min veneer sheet width: 800 mm; • Max veneer sheet width: 1500 mm; • Max height of stacks: 1000 mm; • Exhaust motor: 10 hp 4P (8x); • Inlet conveyor motor: 2hp 8P; • Transport conveyor motor: 6hp 4P; • Hydraulic pump motor: 5hp 4P (3x);