Go Fast Mfg LLC
800-854-7439
Featured Products
Go Fast Mfg D3 Series
Go Fast Mfg D3 Series
The Go Fast D3 Series Deduster not only de-dusts boards, but this compact machine also de-burrs stringy material off of the sides of boards. Still equipped with the Board Knocker System, this deduster will be an asset to any operation.
- SIDE DEBURR BRUSH: A side deburring drum brush is added to remove the stringy material from boards. These stringy materials are usually left over from a band saw cut. A powered wheel holds the boards tight against the spinning brush, ensuring that most of the stringy material is removed.
- Self-Adjusting Hydraulic Powered Hold-Over Wheel
- Board Width Sensing Pressure Plate
- Dimensions
- 103"
- 34"
- 58"
- 27" - 36"
- 34"
- Power
- 208/230/480/3/60 TEFC
- Completely Pre-Wired Motor Starter with Start/Stop Buttons and Circuit Overload Protection
- Capacities
- Up To 6"
- 1/4" - 2.5"
- Unlimited
- Hydraulics
- Self Contained 5 GPM System with Variable 0 - 600 Feet Per Minute Feed Speed
- Machine Options
- Can Quote for Specific Widths
- Can Quote Custom Lengths
- 5 HP Single Phase
- System Options
- Out-Feed Green Chain
- Sorting Round Table
- In-Feed Powered Rollers
- Stacking Racks